garagelat.blogg.se - Platinum notes 4 best settings

#Platinum notes 4 best settings serial number#
#Platinum notes 4 best settings series#

Average Width – Average width or thickness, in pixels, of the laser stripe as captured by the CCD.

too much light reflectivity or absorbency. Lower values could indicate the lens needs to be cleaned or poor optical quality of the surface, i.e. Basically this represents the highest intensity of the laser light as seen by a pixel on the CCD.

Max Pixel - Indicates the highest return power to the Laser Probe’s CCD for a pixel.

Calibration Date – Last Factory Calibration Date.

Firmware Version – Current firmware version loaded on the LLP.

#Platinum notes 4 best settings serial number#

Serial Number – Unique identifier for the Laser Line Probe.The Information frame displays the unique information for the current FARO LLP. NOTE: High Accuracy mode will improve the quality and 2Sigma value of your data but will reduce your field of view by half and shorten your effective maximum scan line width to 2/3 the normal width. NOTE: Adding visible light to the preview window will decrease the number of frames per second sent to the computer and should only be used when diagnosing problems with the FARO Laser Line Probe. 1/1 is all of the points on the laser line, set this to discard points on each line. Scan Density - choose the number of points on each scan line.1/1 is the normal rate of scan lines per second, set this to discard scan lines. Scan Rate - choose the number of scan lines per second.

#Platinum notes 4 best settings series#

For the Scan Rate and Points per Line specifications for your model LLP, refer to the Technical Specification Sheet for the Quantum Series FaroArm and ScanArm. Reducing the number of points the laser probe collects can improve system performance, increase scanning speed and potentially reduce unwanted noisy data. Scan Rate and Scan Density are used for data reduction.

Activate High Accuracy Mode by select the appropriate check box.

Show visible light in the Preview window by selecting the Show Visible Light check box.

Disable the RANGE FINDER dialog box by clearing the Range Finder On/Off check box.

When the Laser Line Probe is within the operating range, a line appears in the Preview Area of the dialog box. 3D Hand Held Scanner - Freestyle3D ObjectsĬhoose the SCANNER SETTINGS button to show the LASER LINE PROBE CONTROL dialog box.